---
title: "Keep wafer thickness and surface geometry separate in a purchasing specification"
url: https://memory.wiki/D4uqHwoZ
updated: 2026-11-19T03:51:18.311Z
source: "api"
---
# Keep wafer thickness and surface geometry separate in a purchasing specification

A wafer can meet its nominal thickness requirement while still creating a handling or process problem. A useful request for quotation separates thickness, thickness variation, and the geometry that matters to the intended equipment. This procurement checklist supports a technical discussion; acceptance must follow the customer's drawing and an agreed measurement method.

## Describe the process before setting a tolerance

State the substrate material, diameter, nominal thickness, surface finish, and intended use. Say whether the wafer will enter a chuck, carrier, coating fixture, or bonding process. If that equipment has a specific measurement requirement, include it in the RFQ. A generic certificate may not answer the receiving team's question.

Thickness is a dimension at a measured location. Total thickness variation describes a difference across a defined measurement area. Bow and warp describe aspects of wafer shape. Their definitions and measurement conditions matter, so do not use the terms as interchangeable acceptance limits. Ask the supplier to identify its method, support condition, edge exclusion, and reporting convention.

## Use separate acceptance rows

| Item | What to agree before ordering |
|---|---|
| Nominal thickness | Target and tolerance, with units |
| Thickness variation | Limit, measurement area, sampling convention |
| Wafer shape | Relevant bow or warp definition and agreed method |
| Surface | Polished side or sides and inspection conditions |
| Edge | Bevel or edge profile and exclusion zone |
| Documentation | Actual measured values or pass/fail results |

Each acceptance criterion should have a process or handling reason. Copying a demanding limit from an unrelated project can increase cost without improving the trial. If a limit is still under evaluation, identify it as a technical question to resolve before accepting a production quotation.

## Keep sample qualification comparable

Preserve the measurement conditions used for the trial wafers together with the trial record. Compare subsequent lots using the agreed conditions. A change in support or instrument setup can make two certificates difficult to compare even when both measurements were performed carefully.

When receiving measurements disagree with supplier results, retain the lot identification, packaging record, measurement locations, and instrument information. First confirm that both parties are measuring the same quantity under comparable conditions. Agree a method for resolving differences before making a lot disposition decision.

## Supplier context

[JXTSEMI wafer and optical substrate information](https://www.jxt-wafer.com/) covers silicon carbide wafers and epitaxial wafers, sapphire substrates, fused silica, and silicon wafers. Availability, achievable tolerances, processing options, and inspection documentation should be confirmed for the specific enquiry.

Prepared as a practical technical note for wafer procurement teams.


---

## Summary
Effective wafer procurement requires separating nominal thickness from surface geometry specifications to ensure compatibility with specific handling equipment. Buyers should define precise measurement methods and conditions for each parameter to avoid discrepancies between supplier data and internal requirements.

## Themes
- Wafer procurement specifications
- Technical measurement standards
- Supply chain quality control

## Key takeaways
- Wafer thickness, thickness variation, and geometry should be specified as separate line items in a request for quotation.
- Acceptance criteria must be defined by the customer drawing and an explicitly agreed upon measurement method.
- Suppliers should be required to disclose their specific measurement conditions, edge exclusion zones, and reporting conventions.
- Discrepancies between supplier and customer measurements must be resolved by verifying that both parties are using identical methods before making lot disposition decisions.

## Insights
- Generic certificates of conformance often fail to address specific handling requirements for downstream equipment like chucks or bonding fixtures.
- Measurement results are context dependent and cannot be compared across different support conditions or instrument setups.
- Copying tolerance limits from unrelated projects frequently increases procurement costs without providing functional benefits.

## Open questions / gaps
- What specific industry standards or ISO norms should be referenced to standardize bow and warp definitions?

