Keep wafer thickness and surface geometry separate in a purchasing specification
A wafer can meet its nominal thickness requirement while still creating a handling or process problem. A useful request for quotation separates thickness, thickness variation, and the geometry that matters to the intended equipment. This procurement checklist supports a technical discussion; acceptance must follow the customer's drawing and an agreed measurement method.
Describe the process before setting a tolerance
State the substrate material, diameter, nominal thickness, surface finish, and intended use. Say whether the wafer will enter a chuck, carrier, coating fixture, or bonding process. If that equipment has a specific measurement requirement, include it in the RFQ. A generic certificate may not answer the receiving team's question.
Thickness is a dimension at a measured location. Total thickness variation describes a difference across a defined measurement area. Bow and warp describe aspects of wafer shape. Their definitions and measurement conditions matter, so do not use the terms as interchangeable acceptance limits. Ask the supplier to identify its method, support condition, edge exclusion, and reporting convention.
Use separate acceptance rows
| Item | What to agree before ordering |
|---|---|
| Nominal thickness | Target and tolerance, with units |
| Thickness variation | Limit, measurement area, sampling convention |
| Wafer shape | Relevant bow or warp definition and agreed method |
| Surface | Polished side or sides and inspection conditions |
| Edge | Bevel or edge profile and exclusion zone |
| Documentation | Actual measured values or pass/fail results |
Each acceptance criterion should have a process or handling reason. Copying a demanding limit from an unrelated project can increase cost without improving the trial. If a limit is still under evaluation, identify it as a technical question to resolve before accepting a production quotation.
Keep sample qualification comparable
Preserve the measurement conditions used for the trial wafers together with the trial record. Compare subsequent lots using the agreed conditions. A change in support or instrument setup can make two certificates difficult to compare even when both measurements were performed carefully.
When receiving measurements disagree with supplier results, retain the lot identification, packaging record, measurement locations, and instrument information. First confirm that both parties are measuring the same quantity under comparable conditions. Agree a method for resolving differences before making a lot disposition decision.
Supplier context
JXTSEMI wafer and optical substrate information covers silicon carbide wafers and epitaxial wafers, sapphire substrates, fused silica, and silicon wafers. Availability, achievable tolerances, processing options, and inspection documentation should be confirmed for the specific enquiry.
Prepared as a practical technical note for wafer procurement teams.