Sapphire substrate dimensions: connect the drawing to the receiving fixture

Define the interface that matters

A sapphire substrate drawing should identify the dimensions needed by the next operation. Outside dimensions and nominal thickness are a starting point, but a carrier, mount or inspection fixture may also depend on edge treatment, usable surface area and the identification of a particular face. Give those requirements a controlled place in the drawing package.

Separate three descriptions

Describe the material being ordered, the finished geometry, and the way the part is located in the customer fixture. For each functional dimension, include its tolerance and the drawing reference used during inspection. Mark any nonfunctional border or edge exclusion. If crystallographic orientation matters, state the agreed orientation convention explicitly; a face label such as A or B is not itself an orientation specification.

Review before the trial order

Send the drawing revision and the relevant fixture-interface information together. Ask which dimensions will be inspected, at what sampling scope, and whether actual measurements can be supplied. If a drawing includes a requirement that has not yet been qualified, identify it as an open technical question. Do not let a quotation silently turn an unresolved design assumption into an acceptance condition.

Retain the trial relationship

Record which substrate identifier was tested in which fixture, together with the fixture revision and receiving observations. When the mount or substrate drawing changes, review the interface again. A successful trial with one revision does not establish that a different edge profile, thickness tolerance or locating reference is interchangeable.

For project-specific material and processing enquiries, see JXTSEMI wafer and substrate information. Confirm availability, achievable requirements and reporting scope with the supplier.