SiC wafer polishing enquiries: assign a requirement to each face

Name the faces on the drawing

A polishing enquiry for a silicon carbide wafer needs an unambiguous way to identify both faces. Use the face names and orientation information agreed for the actual part. Keep the drawing, quotation and inspection request consistent. A front/back convention used by one team may not be understood by another team unless its reference is written down.

Keep the requirements separate

For each face, state whether it is functional in the intended process, what finish is requested, and which inspection evidence is required. Describe the usable region and any exclusions. If only one face has a specified finish, say what condition is acceptable on the other face instead of allowing the absence of a note to become an implied requirement.

Ask what will be reported

Agree which reported characteristic applies to which face, what area it covers, and the reporting convention. Do not substitute a general description such as polished for a defined measurement request. If a particular method matters to the project, name it in the enquiry and ask the supplier to confirm the available scope before placing the order.

Preserve the distinction after delivery

Use the same face convention in the receiving record and any trial-processing notes. Keep supplier lot identification and customer piece identification connected if the wafer is subsequently cut. When a result needs clarification, send the relevant face reference and drawing revision with the question. Avoid comparing two reports until their areas, units and measurement definitions have been checked.

For project-specific material and processing enquiries, see JXTSEMI wafer and substrate information. Confirm the available material, achievable requirements and reporting scope for the actual order.