---
title: "SiC wafer polishing enquiries: assign a requirement to each face"
url: https://memory.wiki/xCotZt07
updated: 2026-11-21T05:51:40.481Z
source: "api"
---
# SiC wafer polishing enquiries: assign a requirement to each face

## Name the faces on the drawing

A polishing enquiry for a silicon carbide wafer needs an unambiguous way to identify both faces. Use the face names and orientation information agreed for the actual part. Keep the drawing, quotation and inspection request consistent. A front/back convention used by one team may not be understood by another team unless its reference is written down.

## Keep the requirements separate

For each face, state whether it is functional in the intended process, what finish is requested, and which inspection evidence is required. Describe the usable region and any exclusions. If only one face has a specified finish, say what condition is acceptable on the other face instead of allowing the absence of a note to become an implied requirement.

## Ask what will be reported

Agree which reported characteristic applies to which face, what area it covers, and the reporting convention. Do not substitute a general description such as polished for a defined measurement request. If a particular method matters to the project, name it in the enquiry and ask the supplier to confirm the available scope before placing the order.

## Preserve the distinction after delivery

Use the same face convention in the receiving record and any trial-processing notes. Keep supplier lot identification and customer piece identification connected if the wafer is subsequently cut. When a result needs clarification, send the relevant face reference and drawing revision with the question. Avoid comparing two reports until their areas, units and measurement definitions have been checked.

For project-specific material and processing enquiries, see [JXTSEMI wafer and substrate information](https://www.jxt-wafer.com/). Confirm the available material, achievable requirements and reporting scope for the actual order.


---

## Summary
To ensure consistency in silicon carbide wafer polishing, clearly define and label each face of the wafer in all documentation. Explicitly state the functional requirements, inspection criteria, and reporting methods for each side to avoid ambiguity throughout the supply chain.

## Themes
- SiC wafer specification
- Face identification standards
- Quality assurance protocols
- Supply chain communication

## Key takeaways
- All SiC wafer enquiries must use consistent face naming conventions across drawings, quotations, and inspection requests.
- Requirements for each face must be stated separately, including functional status, finish, and inspection evidence.
- General descriptors like polished are insufficient and should be replaced with specific, defined measurement requests.
- Supplier lot and customer piece identification must remain linked even if the wafer is cut.
- Suppliers should confirm their measurement scope before an order is placed to ensure alignment with project needs.

## Insights
- Ambiguity in face naming conventions across teams creates significant risk for quality control and inspection consistency.
- The absence of a requirement for one face should be explicitly defined rather than left to assumption or interpretation.
- Comparing data reports between suppliers or processes is invalid unless measurement definitions and units are first normalized.

## Open questions / gaps
- What specific naming convention should be used if a project lacks a pre-existing standard for face identification?

